AmpliVox S1297 - Manual (Page 5)

5
·
Channel Display (A)
·
RF - Radio Frequency Indicator (B)
·
AF - Audio Frequency Indicator (C)
·
ASC / IR Auto Channel Select (Feature Not Used) (D)
·
Select Buttons - Manual Channel Selection (E)
·
Mute Level Adjustment (F)
·
Volume Control (G)
SETUP :
·
The S1297 receiver has its own POWER / VOLUME Control (G).
Make sure that you have screwed on the UHF antenna. Turn Power
On (main power must also be on). A Frequency Channel will ap-
pear in the Channel Display (
A). Press Select Buttons (E) to select
a channel. Channel number must match channel number on wire-
less speaker transmitter.
·
The speaker transmitter ( S1691T) is operated by 1 - "AA" 1.5 Volt
alkaline battery. Slide off battery cover ( H) and install battery as
shown. Make certain the battery is fully seated in its compartment
so the cover slides in place easily. Battery life with alkaline batteries
is approximately 8 hours of operating time.
·
Select a channel (1-16) on side panel ( I) using the supplied screw
driver to select channel number. Channel selected should match
channel on receiver. When transmitter and receiver are set to cor-
rect channel, the
RF indicator (B) will glow red when transmitter is
turned on. When receiver is receiving active signal / sound the AF
indicator ( C) will glow green.
·
Slide the power ON/OFF switch (J) to the ON position (the LED
indicator light will illuminate green). Replace batteries when this
LED turns red.
· MUTE LEVEL (F) is set at half way mark when it leaves the factory.
If speaker sound is breaking up, turn level clockwise with small
screwdriver until condition improves.
Battery Cover Channel Selector
Top Panel
Wireless Speaker Transmitter-S1691T
WIRELESS SPEAKER RECEIVER
G F
D
E
C A B
H
I
J K
SW915
S1297
S1960T Microphone
Transmitter
S1961T Speaker
Transmitter
Supplied Cable
1/4″ to 1/8″
Connect the speaker transmitter ( S1961T) to the LINE OUT jack on the SW915 with the supplied cable, which has a ¼” plug on
one end for the SW915, a 1/8” (3.5mm) plug on the other end for the speaker transmitter.
If using a cable connection instead of the wireless speaker transmitter, connect the LINE OUT jack of the SW915 to the LINE IN
jack of the S1297,
WIRELESS TRANSMITTER CONNECTION
Signal Path