Analog Way Orchestra2 - Manual (Page 23)

23
To properly synchronize the slave device with your Orchestra², you must setup the inputs of the device into
the Orchestra².
1. In the Screen Setup page of the Orchestra², press Edit Inputs.
2. Select the input you wish to parameter, then select the plug type, and the type of signal. The status box (by
the Select Input dropdown menu) should display image resolution and rate.
NOTE: If you are working with a matrix, you can route your image through the matrix via the Matrix Mapping
tab (see also Working With a Matrix).
3. Press the OK button to confirm input settings and return to the Screen Setup page.
The Audio Edit tab will give access to audio in/out parameters
such as levels, balance or volume.
The Edit Sources tab allows to map device inputs, logos or frames to source buttons on the Orchestra² front
panel.
1. In the Screen Setup page of the Orchestra², press Edit Sources.
The buttons in the Source Preview section of the Orchestra²
will light up, allowing you to select the source you wish to
work with.
2. Select the source you wish to parameter, then press Edit to
give the source a new name if required.
NOTE: If you are working with a matrix, you can map matrix inputs to sources, assuming you have defined
links between the matrix and your device in the Edit Inputs page (see the Input Configuration chapter
and the Working With A Matrix chapter).
4.2 Show settings
4.2.5 Input configuration
4.2.6 Audio configuration
4.2.7 Source configuration
3. Press Pattern to generate a pattern on the screen/device plugged to the slave device video out card if you
wish to check the video Out setup.
4. Press TYPE to select the type of signal
5. Press ADJUST to tweak the Gamma value of the output selected.
6. Press the OK button to confirm and return to the Screen Setup page.