BEI Sensors MHK5 Absolute Hollow Shaft Encoder - Manual (Page 20)

DEVICE NET USER MANUAL
BEI IDEACOD SAS
Espace Européen de l’Entreprise
9, rue de Copenhague
B.P. 70044 Schiltigheim
F 67013 Strasbourg Cedex
Tél : +33 (0)3 88 20 80 80
Fax : +33 (0)3 88 20 87 87
Mail : [email protected]
Web : www.bei-ideacod.com
Figure 4 Installation of network
This parameter masks makes it possible to edit
different parameters like monitoring the posi-
tion value. The adjustable parameters are
marked with the number 1-4. The 5th entry
displays the actual position value, when the
function monitoring is activated with the but-
ton start monitor.
The button Load from Device makes it possible
to download the device specific parameter in
the configuration software. So it is very easy to
check the parameter or programming a re-
placement device with the same parameter.
In the same way the control button Save to
Device transmits the edited parameters to the
encoder. Please notice that the transmitted
values are saved in the RAM area. By power
off and on you will loose these parameters.
After checking the parameters they can be
saved in the FLASH memory by selecting the
menu entry UTILITIES-BASIC DEVICE
CONFIGURATION .
The entered values in the mask are taken from
the following figure. This prevent a mistake
through over taking wrong parameters.
Page 20 UME-OCD-D2 Version 05/04