Draw-Tite 75776 MAX-FRAME RECEIVER - Manual

1. Lower and remove spare tire from vehicle. The tire release is located underneath the storage compartment in the back of the vehicle.
2. Remove the access door on rear fascia by removing the two plastic push pins with a #2 phillips screwdriver and pushing the two outside tabs
inward. (Figure 2)
3. Raise hitch into position and insert M12 bolts through the bracket and frame as shown in Figure 1. Note: The plastic bumper locator pin may
interfere with the hitch hardware. If necessary, trim the locator pin at the shoulder to allow proper hardware clearance.
4. Insert M10 bolts through bracket and into the frame as shown in Figure 1 (Hand tighten).
5. Torque M10 bolts first and then M12 bolts to the specifications below.
6. Reinstall spare tire and make sure it is seated properly.
7. Reinstall access door removed in Step 2
Installation Instructions
Hyundai Santa Fe GLS/Limited
(6/7 Passenger)
Part Numbers:
75776
44691
87637
Hitch Shown In Proper Position
Equipment Required: #2 Phillips Screwdriver
Wrenches: 17mm, 19mm
Drill Bits: None
z
2013 Cequent Performance Products, Inc. Sheet 1 of 3 75776N 4/16/13 Rev. A
j
Qty. (4) M12 x 1.75 x 120 Bolt CL8.8
m
Qty. (4) M10 x 1.25 x 30 Bolt CL10.9
k
Qty. (8) 1/2” Conical Washer n
Qty. (4) 7/16” Conical Washer
l
Qty. (4) M12 x 1.75 Nut CL10
Tighten all M12 CL8.8 fasteners with torque wrench to 72 Lb.-Ft. (98 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75776F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 7000 Lb (3401 Kg) 750 Lb (340 Kg)
Weight Carrying
Ball Mount
5000 Lb (2267 Kg) 750 Lb (340 Kg)
Wiring Access Location: SUV1, SUV2
Fascia
Fasteners typical both sides
Frame rail
2 Existing Weld Nuts
(Typical)
Tighten all M10 CL10.9 fasteners with torque wrench to 40 Lb.-Ft. (54 N*M)
Figure 1
Form: F205 Rev C 9-17-2012
Accessory Rating C
jkkl
mn
Plastic Push Pins
Figure 2
Existing Sleeves
Not Shown for Clarity
Access Door