Draw-Tite 75645 MAX-FRAME RECEIVER - Manual (Page 2)

Installation Instructions
Volvo V-70
Volvo XC-70
Note: Fascia trim required
Part Numbers:
Tighten all M10 CL 8.8 fasteners with torque wrench to 38 Lb.-Ft.(52 N*M)
z
2008, 2009, 2010, 2011, 2012 Cequent Performance Products Sheet 2 of 6 75645N 3-8-12 Rev. G
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form: F205 Rev A 5-6-05
Fascia trim required.
Obtain vehicle owners
approval before cutting
2-1/2” [63.5mm]
1-1/4” [31.75mm] 2”
[50.8mm]
Figure 4.
Figure 5.
Figure 6.
Figure 7.
Remove 4 screws (each
side) from the plastic
wheel well molding
Panel to be removed.
Inside appearance
panel at rear of tail
gate
Panel to be removed.
Loosen towing
eye under
appearance
panel, rear
passenger side.
.
Remove 4 screws (each side) from the plastic
wheel well molding.
Gently pull the plastic fascia away from the wheel well molding.
At the tail light pull gently rearward.
Tail light
Rear fascia viewed from bottom.
Volvo XC-70
Plastic fastener from rear
of vehicle to be removed
Loosen towing eye
Fascia shown removed
Note: Installation uses
existing fasteners.
75645, 87484, 44597
75178
(U-Haul)