Draw-Tite 36334 FRAME HITCH - Manual

Installation Instructions
SUBARU LEGACY SEDAN AND WAGON
SUBARU OUTBACK SEDAN AND WAGON
(EXCLUDING SPORT)
Part Numbers:
06377
36334
90138
Hitch Shown In Proper Position Wiring Access Location: PC1, PC2
Equipment Required:
Wrenches: 3/4, 14mm, 17mm
Drill Bits: None
Figure 1.
3500 LB (1589 Kg) Max Gross Trailer Weight
300 LB (136 Kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
36053
Fastener Kit: 36334F
See Figure 2 for Block Combinations
Frame rail
Tow hook
Trunk pan
Existing weld nuts
(both sides)
FASTENERS TYPICAL BOTH SIDES
Optional Drawbar (Sold Separately)
For SEDAN ONLY 36071
Drawbar must be used in the RISE
position only.`
Single block at
all locations
Double block at
forward locations Single block at
forward locations
Without blocks
Existing vehicle bracket
Figure 2.
1. Remove the four muffler hangers (two per side) to allow the exhaust to hang down away from the frame.
2. On the wagon models, remove the forward most bolt (one per side) on the bracket that is bolted to the underside of the frame at the back of the
vehicle. Note: on the sedan and wagon you will need to remove the plastic plugs covering the weld nuts in the vehicle frame.
3. Raise hitch into position and loosely install the tow hook fasteners as shown above.
4. Block locations vary by vehicle model. Attach with block combination that fills gaps between hitch brackets and vehicle frame. Install fasteners
as shown in Figure 1.
5. Tighten 1/2-13 GR5 fasteners to 75 Lb.-Ft. (102 N*M). And tighten M10 CL8.8 fasteners to 38 Lb.-Ft. (52 N*M)
6. Reinstall the four muffler hangers.
Rev. E 12-9-05 36334N Sheet 1 of 3 z 2005 Cequent Towing Products
Block (Small) Qty. (4) 8 Carriage Bolt 1/2-13 X 1.75 Qty. (1) 4
Hex Nut 1/2-13 Qty. (1) 7 Flat Washer 3/8 Qty. (4) 3
Conical Washer 1/2 Qty. (1) 6 Lock Washer 7/16 Qty. (4) 2
Block (Large) Qty. (1) 5 Bolt M10 X 1.25 X 40mm Qty. (4) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form F206 Rev A 5605