Draw-Tite 118261 OEM WIRING HARNESS - Manual

READ THIS FIRST:
Read and follow all vehicle warnings and
installation instructions before beginning installation.
Wear safety glasses and use all safety precautions
during installation.
LISEz CECI En PREmIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes
de protection et respecter les mesures de sécurité.
LEA ESTO PRImERO:
Lea y siga todas las advertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.
118261-037 Rev. A 07/14/2010
Installation Instructions
Directives de montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
ENGLISH
TOOLS REQUIRED:
Test-probe
1. Locate the vehicle’s wiring harness 16-Pin and
4-Pin plugs located in the rear, underneath the
vehicle, inside the driver’s side frame rail. This
harness will have connectors that will mate to the
end of the tow plugs.
nOTE
If only the 16-Pin housing is present, discontinue
installation. Consult application guide for the
Class I wiring harness.
2. Remove factory tow harness protective caps and
check to see if the mating surface is clean and
free of dirt, clean if necessary.
3. Insert the tow plugs into the connectors. Be
careful not to damage the locking tabs and be
sure that connectors are fully inserted with
locking tabs in place.
4. Open the vehicle’s hood and locate the fuse/
relay box on the Driver’s side near the firewall.
Consulting your owner’s manual, locate the
Trailer Tow Battery Charge Relay location and
insert the relay (provided).
5. Route the T-Connector harness along the inside
of bumper toward the center of vehicle.
WARnInG
Route the wire being careful to avoid any hot
pipes, heat shields, the fuel tank or any other
points that may pinch or break the wire.
6. Plug the 7-way socket (provided) into the Trailer
Tow Harness.
WARnInG
Secure all loose wires and mount the Trailer Tow
Harness in an accessible location with a bracket
or electrical box (not included).
WARnInG
All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer once
installed.
WARnInG
Overloading circuit can cause fires. DO NOT
exceed manufacturer’s fuse rating. Read vehicle’s
owners manual & instruction sheet for additional
information.
Ford E-150