Draw-Tite 59401 BIKE CARRIER - TX W_TILT & SECURITY - HITCH MOUNT - Manual

Product Code:
Product Name:
www.rolaproducts.com
Cequent Towing Products - Plymouth, MI
Technical Service: (888) 521-0510
PRINTED IN CHINA
59401N Rev E 11-23-09
59401
ASSEMBLY INSTRUCTIONS
1.
Use key to unlock lock on Collar Bracket.
2. Pull spring loaded release pin on side of Main Support tube, remove handle mechanism, and rotate bike
Support Arms into the UP position. Re-insert the handle mechanism. Pull out the spring loaded release
pin and push handle all the way down. Let the spring loaded pin go so that it fully engages the handle
mechanism.
3. Slide the Collar Bracket onto the bike carrier Main Support tube in orientation shown (see Diagram 1).
4.
Attach Collar Bracket to Main Support tube using one (1) ½” x 3-1/4” lg. hex bolt, two (2) nylon flat
washers, and locknut installed through the “slotted” hole in Collar Bracket. Tighten locknut until it is snug
against the flat washers.
5. Attach Receiver piece to Collar Bracket using two (2) ½” x 3” hex bolts through the
½” diameter holes (closest to end of tube). (See Diagram 2)
Tighten Receiver piece bolts to 75 Lb.-Ft.
7. Lock Collar Bracket to Main Support tube so bike carrier is in the upright position.
1/2” x 3-1/4” Hex Bolt
Please read all instructions carefully before assembly, installation and/or use of this product.
2” Shank
½” Locknut
Diagram 1
Diagram 2
Diagram 3
Handle Mechanism
Release
Pin
4 Place Bike Carrier - Folding
1/2” x 3-1/4” Hex Bolt
½” Locknut
Nylon Washer