Draw-Tite 59400 BIKE CARRIER - TX W_TILT & SECURITY - HITCH MOUNT - Manual (Page 2)

Product Code:
Product Name:
LOADING INSTRUCTIONS:
1.
Place the bike rack receiver into your receiver hitch. Fit rack as close to vehicle as possible.
2. For 2” hitch, secure rack with 5/8” threaded Anti-Rattle Pin with lock washer and clip. (See Diagram 4b)
For 1-1/4” hitch, secure rack with ½” pin and clip (See Diagram 4a)
(Also see Diagram 3)
3. The bikes are loaded onto the rack alternating each bike, with the anti-sway cradle being closest to the seat tube.
(See Diagram 5)
4. Secure the bikes by pulling the bungee straps over the top of the bike frame. The anti-sway straps wrap around the
seat tube prevent the bike from swaying.
5. Check the bungee straps periodically and after stopping to insure that they are still tight and that someone has not
released them. NOTE: Insure all locks are locked, that all pins are secured, and that all bungee straps are properly
attached prior to moving the vehicle. Failure to do so will void the warranty.
59400 / 59403
Please read all instructions carefully before assembly, installation and/or use of this product.
2 / 3 Place Bike Carrier - Folding
Insert ½” pin thru hitch
and install clip. (Also see
www.rolaproducts.com
Cequent Performance Products - Plymouth, MI
Technical Service: (888) 521-0510
PRINTED IN CHINA
59400N Rev H 4/29/13
INSTRUCTIONS FOR FOLDING THE RACK:
1.
To release the lock pin, pull Bail Pin. (See Diagram 2)
2. Pull support tube firmly upwards until lower pin slides to the top of its slot.
(See Diagram 6)
3. Lower the tube slowly back until support tube rests on the stop plate.
NOTE: Do not drop or let the support tube fall freely. Make sure that your
hands and fingers are clear of the hinging area during this operation.
4. To restore the rack to the upright position, do reverse procedure.
5. Check periodically to insure you have a solid fit between the Support
Tube and the Collar Bracket.
Diagram 6
Diagram 4b
Used in 2” hitch
Anti-Sway Cradle
Diagram 5
Insert 5/8” threaded Anti-Rattle Pin with 5/8” flat
washer thru hitch, tighten, and install clip.
(Also see Diagram 3)
and install clip. (Also see
Diagram 3)
Diagram 4a
Used in 1-1/4” hitch