Draw-Tite 59502 CARGO CARRIER - HITCH MOUNTED - Manual

Product Code:
Product Name:
Cequent Consumer Products Inc
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
www.rolaproducts.com
Cargo Carrier
59502
Please read all instructions carefully before assembly, installation and/or use of this product.
TOOLS REQUIRED: 1/2” Wrench, 5/8” Wrench, Torque Wrench
WARNING: The Maximum capacity is 600 pounds.
DO NOT EXCEED lower of vehicle mfg’s or hitch mfg’s maximum tongue weight rating.
WARNING: Not for transport of people, animals, or flammable liquids.
WARNING: If the load or cargo carrier blocks or impairs visibility of the taillights or turn signals, use light kit #20174.
WARNING: If the cargo carrier or the contents being transported is in line with the exhaust outlet, an exhaust tip must be
used to redirect the exhaust flow away from the cargo platform or contents.
WARNING: Do not lubricate threads. Bolt failure may occur due to over tightening.
WARNING: Securely fasten load to cargo carrier. Do not carry any loads wider than your vehicle.
WARNING: Do not drill or weld to this product.
WARNING: Relocate license plate if blocked by load or cargo carrier.
NOTE: Requires 5/8” Pin & Clip (sold separately)
ASSEMBLE CARGO CARRIER
• Place each half of cargo tray on a flat
surface with the cargo mesh floor
facing down as shown. Line up the
locator tubes and connect the two
halves to each.
• Using four 3/8 hex bolts and lock nuts,
attach the chrome support tubes to the
outer surface of the mounting tabs on
the cargo carrier. Leave bolts loose at
this step.
1
3/8 x 1.00” HEX BOLT
3/8 LOCK NUT
(4 PLACES)
LOCATOR
TUBE
MOUNTING TABS
CHROME
SUPPORT
TUBE
2 • Turn cargo carrier over so that the
mesh floor is facing upward as shown.
• Install four 3/8 hex bolts and lock nuts
through holes in angle brackets.
• Tighten all 3/8-16 GR5 bolts to 31 ft•lb.
3/8 x 1.00” HEX BOLT
3/8 LOCK NUT
(4 PLACES)
Page 1
59502N Rev A 4-5-05