Draw-Tite 59108 ADVENTURE SYSTEM - Manual (Page 2)

Product Code:
Product Name:
Cequent Consumer Products, Inc.
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
www.rolaproducts.com
59108 Rev A 1007
Adventure System
– Class II
59108
Determine the appropriate setting for bumper fascia clearance (reference Fig A), and attach the support brackets to the Main
Support. Install the 3/8” x 1.25” hex bolts, flat washers, lock washers and hex nuts through the holes in support bracket and
through the holes in plates on the Main Support as shown in Fig B.
NOTE:
Attach support brackets with the flanges to the inside as shown. Tighten 3/8” hex bolts to 30 ft-lb.
Please read all instructions carefully before assembly, installation and/or use of this product.
Page 2 of 5
3
SPRING CLIP
1/2” PIN
SUPPORT BRACKET FLANGES MUST BE
TOWARD THE INSIDE AS SHOWN
3/8” x 1.25 HEX BOLT
3/8” FLAT WASHER
3/8” LOCK WASHER
3/8” LOCK NUT
(BOTH SIDES)
Fig B
Fig A
Setting (1)
3/8” x 1.25 Hex Bolts
Setting (2) – Additional clearance
3/8” x 1.25 Hex Bolts