Draw-Tite 59109 ADVENTURE SYSTEM - Manual (Page 4)

Product Code:
Product Name:
Cequent Consumer Products, Inc.
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
www.rolaproducts.com
(T258) 112816 10-18-05 Rev A
Adventure System
59109 / 59110
5
Remove the Bumper Pack (some models) from the Cargo Tray by opening the two latches that secure
the Cargo Tray to the Bumper Pack.
Rotate the Bumper Pack up as shown and pull it away from Cargo Tray.
Cargo Tray to Bumper
Pack Latches
Please read all instructions carefully before assembly, installation and/or use of this product.
Page 4 of 27
Install the bail pins into the holes with the support brackets in the folded down position. 6
INSERT BAIL PINS For Tilt-Up
MODELS ONLY
4
To secure the wiring harness to the Swing-Away frame, remove the Bail Lock Pin from and lift up on latch
handle and open up the Swing-Away frame until it stops.
WARNING: Always keep hands and fingers away from latch mechanism and hinge while
operating the Swing-Away. Starting from one end, place the wiring harness along the bottom surface
of the main support and attach using the six cable ties supplied. For best results, the cable ties should be
equally spaced as shown. Note: Be sure to locate the correct end of wiring harness as indicated in the
diagram below.
For Swing-Away
MODELS ONLY
Vehicle side
4-way flat
(3 Prong Male End)
Accessory side
4-way flat
Cable Tie - 6 Places
Wiring Harness
Bail Lock Pin
Latch