Draw-Tite 59109 ADVENTURE SYSTEM - Manual (Page 8)

Product Code:
Product Name:
Cequent Consumer Products, Inc.
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
www.rolaproducts.com
(T258) 112816 10-18-05 Rev A
Adventure System
59109 / 59110
General Operating Instructions continued
•To install Bumper Pack to Cargo Tray, lift Bumper Pack up and over tray. Rotate the Bumper Pack down
toward the lights so the two connector pins properly engage the tie-down slots in cargo tray as shown above.
•Seat the Bumper Pack into the Cargo Tray.
•Latch and lock the Cargo Tray/Bumper Pack latches before every use.
Note: The latch keys are taped to the inside of the lid of Bumper Pack.
Please read all instructions carefully before assembly, installation and/or use of this product.
Page 8 of 27
CONNECTOR PIN LOCK LATCHES
BEFORE EVERY USE
•To use Tilt-Up feature, remove bail/lock pins and tilt Cargo Tray into the up position and install both
bail/lock pins into the holes.
Note: Do not drive with the Cargo Tray in the tilted up position. This feature is to be used only when the
vehicle is parked and the unit is not in use.
•Cargo tray and bike rack accessory may be tilted up when not in use. Make sure Bike Rack System is fully
secure before tilting up toward your vehicle. (Clearance for tilting may not be available on all vehicles.)
WARNING: Both bail/lock pins must be used to secure support brackets in tilted up or down positions.
Latch Closed
Latch Opened Latch Partially Closed - INCORRECT