Draw-Tite 59753 ROOF RACK - Manual

PART No.
Carrying Capacity
Tools required to install
K
IT
C
O
M
P
O
N
E
N
T
S
50 kgs
110 lbs
59753
A
B
C
D
E
F
G
H
I
J
K
A
D
E
Direct mount System
For use on fiberglass caps
Use with ROLA APE and APX cross bar kits
L
Part Description Qty
A Button head bolt M5 x 35mm 8
B Nylon washer 8
C Washer-M5 8
D Hex nut- locking 8
E Screw end protector cap 8
F Screw Phillips head M6 x 20mm 1
G ROLA cover 4
H Direct mount adapter base 4
I Brass Nut M6 4
J Rubber mounting gasket 4
K Hex key- 3mm 1
L Silicone sealant 1
Tools required:
A Masking tape F Safety glasses
B Tape measure G Phillips Screw Driver
C 8mm wrench H 1/8" Drill bit
Placement of Track Rails onto Vehicle surface (truck shell shown)
Page 1 of 2
Use of ROLA direct mount system with bolts is intended
for fiberglass top installations.
Install requires drilling and permanent installation of
tracks.
Installation requires some tools and skill. If concerned
please have professionally installed.
Caution- never exceed the load rating for your
vehicle (contact manufacturer for details), or
that of your cross bar system which ever is
lower.
Precaution Warnings before beginning
Printed in China
B
C F
59753N Rev A 2-11-13
Remove covers from adapter
bases if attached.
Assemble cross bars to desired width
and attach to adapter bases
Align cross bars on vehicle in desired
position. Consider accessory spacing
and potential underside interference
C 8mm wrench 1/8" Drill bit
D Fine tip marker I 1/4" Drill bit
E Drill motor
CAUTION
H
I