Draw-Tite 59753 ROOF RACK - Manual (Page 2)

Preparing fiberglass surface for mounting
Once aligned correctly tape
adapters to surface. Carefully
remove cross bars.
Mark mounting holes with fine
tip marker or pencil
Note: wear safety glasses
during installation. Drill 1/8”
pilot hole first, then drill ¼”
size holes. Never drill deeper
than ¼”. Note- not advisable
to drill through adapters.
Important- Use drill stops or wrap
masking tape around the drill bits to
ensure drilling no deeper than ¼”
below truck cap
Blow away any debris.
Apply a generous amount of
silicone around holes before
mounting adapter bases
Install M5 x 35mm bolts and
nylon washers through adapter
and rubber gasket and into the
fiberglass mounting holes.
Firmly secure bolts with hex
wrench.
Be sure to install M6 hex nut
into bottom of adapter.
M6 hex nut
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle should
therefore be driven with increased caution. Check the function of all doors and sunroof before driving.
For lost key replacement or other service items call customer service: 1-800-632-3290 or visit:
www.rolaproducts.com
Please have lock core number or part numbers available.
Loads should be evenly distributed and secured.
59753N Rev A 2-11-13 Page 2 of 2 Printed in China
Bolts may be covered with
protector caps if desired.
ROLA carries a variety of cross bar styles and lengths to attach to our direct mounting kits. Cross Bars are sold with
mounting hardware.
Install covers when cross bars
are not installed to keep debris
out of adapters and avoid wind
noise
Attaching Cross Bars and tightening hardware
Re-Install cross bars onto adapter bases
and tighten anchor point screws firmly
into adapter nuts
mounting adapter bases