Draw-Tite 59722 ROOF RACK - Manual

59722, 59723,
59724
PART No:
Fitting Instructions
APE (Anchor Point Extended)
Cross Bar Kits with Adapter
Bracket
CARRYING CAPACITY:
Pg 1 of 2
50Kgs/
110 Lbs
Printed in China
Note: Prior to Assembly
Prior to assembling your cross bar kit check that the kit contains all the parts you will need to fit the cross bars.
Refer to parts lists for guidance. Please read these instructions before assembly.
Step 2: Installing Rubber Gaskets and Adaptor
Position the rubber gaskets over the anchor points as
shown in (fig. 2).
Ensure that the gasket is properly aligned.
If your gasket has a directional arrow this always points
toward the front of vehicle.
Ensure that the gasket slots are centered over the
anchor point threads in the roof.
Place the plastic adaptors
into the gasket’s recessed
top surface (fig. 3).
Cross Bars
End support
Plastic adaptor
Rubber Gasket
M8 x 20mm Bolt
Clamp plate
M8 spring washer
M8 washer
L wrench
M6 mounting bolt
M8 hex nut
Cross bar
end caps
13mm or adjustable wrench
Plastic adaptor
Vehicle’s roof
Anchor point
Rubber Gasket
Front of
vehicle
Vehicle’s roof
Location of anchor points on vehicle
Fig. 2
Fig. 3
Parts list
End cap key
ROLA Adapter Bracket
Fig. 1
Anchor Point Cover
Remove existing clip bracket. Keep bolts
to fasten ROLA Adapter Bracket.
Remove Anchor Point Cover. Fasten ROLA Adapter Bracket
with same bolts.
A B C
Sept 1: Removing the vehicles anchor point covers
On the vehicle roof you will find 4 Anchor Point Covers. Carefully remove these covers by sliding in the
direction shown on the cover, to reveal the clip bracket (fig. 1-A). Using a 10mm socket wrench, replace
existing clip bracket with the ROLA Adapter Bracket reusing the bolts that secured the clip bracket, as shown
(fig. 1-B & C).
NOTE: Take care when removing Trim Covers to avoid damaging Trim Cover Clips. Covers can not be replaced
while rack is mounted. Covers can be replaced over the ROLA supplied Adapter Bracket. Store the Anchor
Point Covers and existing brackets safely while the Roof Racks are in use.
10mm socket and wrench
Tools
needed
59722-3-4N Rev 2-20-12
Under Cover