Draw-Tite 118415 T-ONE CONNECTOR - Manual

6. Locate a suitab le grounding point near the
connector such as the vehicle's frame or cross
member
k . (Do not drill into vehicle floor or
bed.) Clean dirt and rustproofing from area.
Drill a 3/32" hole and secure
white wire using
eyelet and screw provided.
CA UTION
V erify what is behind any surface prior to
drilling to avoid damage to the vehicle and/
or personal injury. Do not drill into any
exposed surfaces.
W ARNING
All connections m ust be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
7. Mount the T-connector b lack bo x using
double-sided tape provided k . Secure the
remainder of the T-connector harness with
the cable ties provided. To prevent damage
or rattling, be careful to avoid any areas
that would cut or pinch the wire.
8. Reposition the access panels , trays and trunk
floor panels and reattach the threshold.
NO TE
Store 4-Flat in tr unk or rear cargo area when
not in use.
W ARNING
Ov erloading circuit can cause fires. DO NOT
exceed lower of towing manufacturer rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (5.0 amps)
Read vehicle's owners manual & instruction
sheet for additional information.
ENGLISH
TOOLS NEEDED
10mm Soc ket & Ratchet or 10 mm Wrench,
Drill, Phillips Head Screwdriver, Test Probe
1. Open the v ehicle’s rear tailgate. On the
driver’s side remove access panel to locate
rear of taillight
d . Repeat on the passenger
side. Remove threshold, trunk floor panels and
trays
e f g h . Set aside all items removed
being careful not to damage parts.
2. Remo ve two screws in the threshold plate
area i , to gain access behind tr im panels.
Being careful not to damage clips, partially
remove the lower interior trim panels on each
side of the vehicle
j . Set aside all items
removed being careful not to damage parts.
3. On the dr iver and passenger sides of the
vehicle, locate the vehicle's taillight wiring
harness
k . The taillight wiring harness will
have a connection point, on both sides,
matching the ends of the T-Connector.
Separate these connectors, being careful
not to break the locking tabs. All connector
surfaces should be clean and free of dirt .
4. On the dr iver’s side insert the T-Connector
end, with the y ellow wire , between the vehicle
wiring connectors and lock into place. Be sure
that connectors are fully inserted with locking
tabs in place.
5. Route the T-Connector end with green wire
to the passenger's side. Repeat step 4 on
the passenger's side with T-connector end
containing the
green wire .
118415-037 Rev. A 06/27/06
Installation Instr uctions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
READ THIS FIRST:
Read and f ollow all instructions carefully
before beginning installation.
LISEZ CECI EN PREMIER:
Lire et suivre toutes les instr
uctions
attenrivement avant le montage.
LEA ESTO PRIMERO:
Lea y siga todas las instr ucciones cuidadosa-
mente antes de iniciar la instalación.
•
f
•
i
•
e
•
g
•
j
•
h
•
d
•
k