eLine Technology SIP-VD-R - Manual (Page 10)

9 10
7
Arrow on camera base
Arrow on camera
7.Re-attach the
dome cover.
Align the arrows
as shown in the
diagram to
ensure a
waterproof seal.
Use the allen key
to tighten the
tamper screws.
module (inside camera) NOTE:Makesure
dome cover cord
Correct Arrow Alignment
Arrow on dome cover does not get
caught in the
rubber seal.
Junction
4. JUNCTION BOX PLATE
Junction box plate is used to install camera into standard 4S and Octagon
junction boxes. Junction box plate screw kit contains the following
accessories:
• 3 x Base fitting screws (PWM3 Type)
• 4 x 2S / 4S plate screws (KM3.5 Type)
• 2 x Octagon fitting screws (KM4 Type)
Base Fitting Screw Octagon Screw 2S / 4S Screw
4.1 Junction Box Plate Dimensions and Fitting
eLineTechnology.com