eLine Technology SIP-VD-R - Manual (Page 8)

5 6
3. CAMERA INSTALLATION
Make sure to follow the correct polarity if connecting
the camera to DC power. Polarity is marked on the
power connector.
All Installation Methods
1
1.Loosen the three tamper screws
using the provided allen key. Lift the
dome cover.
NOTE: If you plan to use conduit fitting,
remove conduit cap using the provided
conduit key.
Allen
Key
Conduit
Key
Mounting
Template
Method 1 - Direct Attach Install
2a
2a. Use the included mounting
template (Installation Option 2) to mark
and pre-drill the required holes.
Remove 2 of the 3 base locking screws.
Use 2pc of the 2.8” screws to mount the
camera directly to the mounting
surface.
Remove the 3rd base locking screw and
install the 3rd 2.8” screw.
Go to step 4 to complete installation.
Method 2 - Camera Base Install
2b. Use the included mounting template (Installation Option 1) to mark and
pre-drill the required holes.
2c/2f
2d
2g
2c. Remove the camera
base by unscrewing the 3
base locking screws, and
turn camera module
approx. 5 degrees
counterclockwise to detach
camera base from the
camera module.
2d. Install the base to the
correct holes as indicated
on the mount template
using the 1.2” screws.
Go to step 3a to complete
installation.
Method 3 - Junction Box
Install
2e. Attach provided fitting
plate to junction box (see “5.
Junction Box Installation
Types” on page 11).
2f. Remove the camera
base by unscrewing the 3
base locking screws, and
turn the camera module
approx. 5 degrees
counterclockwise to detach
camera base from camera
module.
2g. Install the base to the
junction box plate using the
base fitting screws.
Go to step 3a to complete
installation.
eLineTechnology.com