eLine Technology SIP-FB - Manual (Page 17)

23 24
Configuration
• Frame Rate: Select the frame rate for the stream up to maximum of
30FPS for stream1 or stream2 or 12FPS for stream3.
NOTE: Frame rate may be automatically adjusted to account for bandwidth
limitations.
• I Frame interval: Select the interval for I frames: 1, 2, or 3. The default
value of 2 should be used unless there are special requirements. The I
Frame interval does not apply to stream3.
• Bit Rate: For stream1 or stream2, select CBR (Constant Bit Rate) or VBR
(Variable Bit Rate). Enter the desired bit rate below in kbps. Stream3 only
supports VBR.
• Quality: Select the video quality between 1 (lowest) and 9 (highest).
TIP: A quality of 7 provides a good picture. It is not recommended to set a
high quality value with a small VBR bit rate.
3. Click OK to apply changes.
6.7 Device Configuration
Device Configuration contains the following sub-menus:
• Local Network
• Device Port
• Camera
• Date & Time
• OSD
• Microphone
• BNC Video Output
• Language
• Multicast (Not supported)
• Dome PTZ (Not supported)
Configuration
6.6 Stream Configuration
The Stream Configuration page allows you to configure the camera’s video
streams. The camera supports three different video streams. This allows
you to have a high quality recording stream (stream1), a lower quality stream
(stream2) to preserve bandwidth for remote connections, and an MJPEG
stream for applications requiring MJPEG.
To configure video streaming settings:
1. Click Stream Configuration. Under Stream ID, select the stream you
would like to configure.
2. Configure the following:
• Video Encode Type: Select the Video Encoding type for the stream.
Stream1 and stream2 can be configured for H.264 High Profile, H.264
Main Profile, or H.264 Base Profile. Stream3 supports MJPEG only.
• Audio Encode Type: Select the Audio Encoding type for the stream:
G711_ALAW, G711_ULAW, or RAW_PCM.
• Resolution: Select the resolution for the stream. Stream1 and stream3
can be set to 1920x1080 or 640x360. Stream2 can only be set to 640x360.
Stream3 can only be set to 1920x1080.
eLineTechnology