eLine Technology SIP-FB - Manual (Page 6)

1 2
1. GETTING STARTED
The system comes with the following
components:
• 1 x Camera
• 1 x DC IRIS connector
• 1 x Adapter ring
• 1 x RJ45 Coupler
• 1 x Quick Start Guide
• 1 x Instruction Manual
• 1 x Top mounting pack
• 1 x Software/Documentation CD
RJ45 Coupler
1.1 Default Camera Username, Password, and Ports
Username: admin
Password: admin
Ports: 80 (HTTP), 30001 (Control/Streaming), 8080 (RTMP), 554 (RTSP)
IP Address: DHCP Enabled by Default (Router will automatically assign IP
address)
NOTE: Once you have completed the basic setup of the camera, it is
recommendedto configure astatic IP address. This will prevent the camera
IP address changing in the event of a power failure. For details, see “6.7.1
Local Network” on page 24.
1.2 Camera Overview
Interface Connection
Network interface RJ45 Interface. PoE socket
Audio input Connect to audio input device, such as tone alarm
Audio Output
Connect to acoustics device, such as speaker etc. for audio
speech output(impedance: >16Ω)
Power (DC12V) Camera Power if not using PoE
Alarm output
(COM OUT)
Connect to alarm output, 1 channel on-off parameter(the
connected power must be within range of DC12V and 300mA)
Alarm (COM IN) Alarm input, 1 channel signal alarm（0~DC12V）
RS-485 interface Connect to RS-485 device, such as Pan/Tilt, PTZ etc.
SD card socket Insert SD card for local storage
Video Output Service Video Setup / IP setting info., standard BNC interface
RESET RESET button, restore ex-factory value. Hold for 5 seconds.
*microSD card slot (max. 64GB supported; recommend SanDisk™/Kingston™
DC IRIS
1 Control +
2 Control -
3 Drive -
4 Drive +
eLineTechnology