EXP Computer CRW with CDROM Card - Manual (Page 27)

- 21 -
SOFTWARE INSTALLATION FOR OS/2 WARP
Before installing the external CD-RW device driver for OS/2 WARP, make sure your computer is
PCMCIA supported. If you are not sure about this, please refer to the last part of this chapter for
‘Adding PCMCIA Support’.
Automatic Installation
1. Insert the device driver diskette into floppy drive on your computer.
2. Open ‘OS/2 WARP’, and then open ‘Drives’.
3. Select Drive A or B depending on which floppy drive contains the device driver diskette.
4. Open ‘OS2WARP’ folder. Then double-click on ‘INSTALL2.EXE’.
5. A dialog box will be displayed for you to specify the
OS/2 directory, the I/O address for the CD-RW and the
IRQ number. After specifying the OS/2 directory, press
TAB to set the I/O port and then the IRQ. The default
setting of the I/O ports is (170-177, 376-377), and the
default IRQ is 15. After completing the selection, press
TAB to the Install button and press ENTER to continue.
6. The rest of the installation will proceed automatically. At the end, the on-screen instruction will
prompt you to restart your computer to activate the external drive for OS/2 Warp.