EXP Computer ThinLan 100 - Manual (Page 10)

DEVICE=C:\DTECTEN.EXE /IRQ=11 /MEM=D8 /IO=300
If you load the direct enabler without any switch, the program will use all default
parameters. (IRQ=11, Memory=D800 and I/O Base address=300)
The direct enabler can also run as a DOS command line or by including it as a
line on your AUTOEXEC.BAT file.
The following switch are additional command line options:
/SKT=z PCMCIA’s card socket number (z=0-7)
The SKT switch can be omitted, since the directen.exe can
automatically detect the slot where the adapter is installed.
/o Overwrite current socket settings
/? Display list of option
The line should look like this (use all default setting)
DTECTEN.EXE /IRQ=11 /MEM=D8 /IO=300
Installing Card Services client driver
Most of the notebook manufacturer today install the PC Card (PCMCIA) Card
Service and Socket Service as part of the system. (see Appendix A for a sample of
driver entries in the config.sys from various notebook computer) The csdriver.exe
can be loaded AFTER all Card Service and Socket Service driver or at the DOS
prompt. The config.sys line for Card Service client driver has the following syntax:
device=[path]\csdriver.exe [/IRQ=x] [I/O=nnn]
/IRQ=x Interrupt request number (x=3, 4, 5, 9, 10, 11, 12, and 15)
Default = 11
/IO=nnn I/O range (nnn=300, 320, 340 and 360)
Default = 300
The line should look like this (using all default setting)
DEVICE=C:\DTECTEN.EXE /IRQ=11 /IO=300
NOTE
For LAN Manager installation, the Card Service Client Driver must be loaded
right after Card Service and Socket Services but before the LAN Manager
drivers are loaded.