EXP Computer ThinLan 110 - Manual (Page 8)

From the Network settings screen you should be able to select and configure the
network protocol, change the computer name etc. Consult the Windows NT users
manual.
WINDOW 4.0 INSTALLATION
First time installation
This section is for users whose computers are not Windows NT pre-installed. If
your computer is already Windows NT installed, skip this section and go to next
section for Adding the ThinLan PC Card directly.
During the initial installation you will have an opportunity to add a Network
function. Make sure to select the “This computer will participate on a network””
and also make sure the ”Wired to the network:”box is checked. Then click next,
Select “from the list”, then click Have disk button. From the Insert Disk screen
type in A:\WINNT, click OK.
At the Select OEM Option the ThinLan PC Card should be highlighted. Click OK.
The default setting IRQ Level and the I/O Port Address can be changed if
necessary. If you decide to choose different resources settings for the card, make
sure that the new resources are not conflicting with some other device.
To finish the rest of the set up procedures, you will need to set up network
software ( Protocols, Services, Binding etc.). Go to Control Panel and click on the
Network icon. Follow the instructions in the following “Adding ThinLan PC Card
“ section.
Adding ThinLan PC Card
This section is for users whose computers are Windows NT installed. If your
computer is not yet Windows NT installed, go back to the previous section to
install the ThinLan PC Card during the Windows NT installation.
To install the ThinLan PC Card, perform the procedures described below.
Go to Control Panel, click on Network icon.
The Network dialog box will be displayed. Click Adapters tab, and click Add
button. Then the Select network Adapter screen will be displayed, click Have Disk
button to continue.
From the Insert Disk screen type in A:\WINNT. Click OK.
Then select the ThinLan PC Card from the Select OEM Option screen.
See the figure listed below for default setting for the card. The default IRQ Level
and I/O Port Address can be changed if necessary. Click on Continue button.