Biamp CobraNet Firmware Upgrade Procedure User Manual
Biamp Audio
BIAMP SYSTEMS TECHNICAL SUPPORT GROUP
www.biamp.com
•
Page 1 of 2
PROCEDURE
1.
Go to the Cirrus Logic download site located in the following link: http://cobranet.info/downloads
2.
Download CobraNet Discovery Utility (Disco) to your desktop (Version 4.0.5 or later)
3.
Double click on CNDisco_4_0_5.zip and install the appropriate version for your operating system. Please
note that Disco will not create a desktop icon
4.
Go to the Biamp Systems download site located in the following link:
http://biamp.com/downloads.php
5.
Under software and firmware, select CobraNet firmware and download to your desktop
(AudiaCobraNetFW.exe)
6.
Double click on AudiaCobraNetFW.exe and click on “Unzip” to extract the files. Save the files in the default
location.
7.
Open the TCP/IP properties of your computer by going to the Control Panel > Network Connections > Local
Area Connection. Select Internet Protocol (TCP/IP) and click Properties.
8.
Select “Use the following IP Address” and set a static IP Address. Set the Subnet Mask to 255.255.255.0 and
click “OK”
Figure 1 – Set a static IP Address
9.
Connect the Ethernet port on your computer to the same network switch as the CobraNet devices on your
network. You can also connect directly to the CobraNet port on the Audia unit with a cross-over cat5 cable.
10.
Open CobraNet Disco by going to Start > All Programs > CobraNet Discovery > CobraNet Discovery
11.
Open the options menu by going to Tools > Options
12.
Make certain your network card is selected under “Network Adapter” and click on “Enable Auto Assignment”
to select it. Click “OK”
CobraNet Firmware Upgrade Procedure