Biamp CobraNet Firmware Upgrade Procedure User Manual
Page 2
BIAMP SYSTEMS TECHNICAL SUPPORT GROUP
www.biamp.com
•
Page 2 of 2
Figure 2 – CobraNet Disco settings
13.
All units connected to the CobraNet network should appear in the CobraNet Disco window. If not, Click view
> Refresh. Each line shows each individual unit, an IP address, MAC address and current firmware version. If
a device times out, power cycle the unit by unplugging the power cord.
14.
Select the device(s) to have firmware upgraded and go to CobraNet > Update Firmware…
15.
Select the appropriate firmware version from the list and click “Update”. This process will take about 30 – 60
seconds.
16.
Power cycle the unit when prompted to do so and click “OK”
17.
After the system boots up, go to View > Refresh to verify that the firmware was installed.
If this application note did not answer your questions on the topic of “CobraNet Firmware Update Procedure”,
please contact Biamp Technical Support Group by phone at + 1 800 826 1457 or by email at
.