Biamp TEC-1 - Manual (Page 12)

12
TEC-1i INSTALLATION
When installing the TEC-1i using the retrofit plate or the back-box, fasten the trim ring using the four screws
provided to either the retrofit plate or the back-box. Once the trim ring has been fastened to the retrofit plate
or the back-box, guide the TEC-1i front plate at an angle into the top of the trim ring to seat the tabs on the
top of the front plate. Once this has been done rotate the bottom of the front plate towards the bottom of the
trim ring until it is seated in the trim ring via the bottom clip.
If the front plate needs to be removed use a screw driver or other suitable tool to engage the latch at the
bottom of the TEC-1i to detach from the trim ring.
Refer to page 13 for instructions regarding the use of the insulation displacement connector.
Exploded view showing pieces required for mounting to the retrofit plate
or the Raco 254 box
Front Plate
Retrofit Plate
Raco 254 box
Trim Ring