Auralex Acoustics Elite Pro Systems EPS-168T User Manual
Page 3
CT45 Bass Trap Installation Guide
16.75”
➊
Mark a vertical line 16.75” from the intended
placement corner on both sides.
➋
Hold
CT45 Bass Trap in corner with edges
aligned to the marked vertical lines.
➌
While continuing to hold panel in place, install
one finish nail though the fabric face and the
hardened edge of the
CT45. Make sure finish
nail is installed perpendicular to the wall surface.
Repeat in each of the four corners.
➍
Using a nail set or other finish nail, carefully
countersink installed nail so its head goes
through the fabric surface of the
CT45 but not
through the hardened edge.
➎
Once finish nail has been countersunk into the
panel, there may be a small hole remaining in
the fabric covering. Simply scrape the fabric in
this area with your fingernail and the hole will
completely disappear.
TIP
When using lighter colored fabrics,
make sure your hands are clean!