Auralex Acoustics Elite Pro Systems EPS-168T - Manual (Page 4)

Elite Pro System Installations
See the Auralex ® Acoustics website, www.auralex.com , for more information
about these and other Total Sound Control ® products.
These are general recommendations. Should you have any additional questions about the installation of your
Elite Pro System , feel free to contact an Auralex ® Application Specialist
via email at [email protected] or call 1-800-95-WEDGE .
➋
Within traced ProFusor outline, mark another
rectangle 4” in from both sides, 5.25” down from
the top and 2.75” up from the bottom. Install one
Z-
Clip in each corner of the marked inner rectangle
using drywall screws, as shown.
➊
Hold the ProFusor to the wall or ceiling in its
intended location with the back facing out.
Make sure diffusor is level. Completely trace its
outline.
4”
5.25”
2.75”
4”
Marked inner
rectangle
Traced
ProFusor
Outline
➌
On the back of the ProFusor, mark a rectangle 4”
in from the outer edge on all sides. Install one Z-
Clip in each corner of the marked inner rectangle
using drywall screws, as shown.
4”
4”
4”
4”
➍
Set ProFusor into place.
Wall