ELRO KT100 - Manual (Page 6)

6
cooling system
14 (OK) Save settings/return
15 (MODE) Changing of (1c/2c), (DLY),
(CL/HT).
16 (reset) Reset/Return to factory
settings
2.2 Overview display LD 2
17 Day of the week
18 Time
19 Indicator for output signal
from thermostat to heating
and cooling system
20 Ambient temperature/set
temperature
21 Selected program number
22 Program profile, distribution
of comfort and economic
temperature throughout the
day.
23 Status indicators:
Low battery
Comfort temperature
Economic temperature
Frost protection mode
Manual mode
(CL) Controller for cooling
system
(HT) Controller for heating
system
(DLY) Delayed start heating/
cooling
(1°) Allowable temperature
fluctuation 1°C
(2°) Allowable temperature
fluctuation 2°C
3 Assembly and installation
To assemble and install the thermostat,
follow the steps below:
• Hold the template against the
spot where you want to install the
thermostat. Use the cross marks on
the template to drill two holes in the
wall. Use a drill of 6 mm 4
• Insert the plugs into the holes 5 .
• Lead the two wire cable (these come
from the device to be connected)
with the green terminal block at the
back of the thermostat 6 . In most
cases these are the connections “NO”
and “COM”. Refer to the manual of
the heating or cooling system to be
connected.
• Insert a screw into the left plug. Make
sure it protrudes approximately 5 mm.
Place the thermostat on the screw
and slide it to the right. Insert the
other screw into the right plug through
the battery holder 7 .
• Place the batteries 8 .
4 Operation of the thermostat
4.1 Setting the time
Choose the day of the week with “day”
(5). Choose the time in hours with
“hour” (6) and the time in minutes with
“min” (7).
Tip! Press and hold any key for
more than 2 seconds to change the
time rapidly. Release the key when the
desired time is reached.
4.2 Setting the temperature
The thermostat works on the basis of
three temperature settings:
: Comfort temperature. This is the
temperature that you use for your per-
sonal comfort.
: Economic temperature. This is the
temperature that you use to save ener-
gy, for example, when you are not at
home or when you are sleeping.
: Frost Protection Temperature. This
temperature is 7°C and you cannot
change it.
You can adjust the comfort and eco-
nomic temperature from 5 thru 30°C
as desired. The set temperature is
then maintained within the selected
programs.
Set the temperature as follows:
0504_ELRO_KT100 thermostat_CH_130x73_2.indd 6 07-09-12 15:32