Fluid Components International MT86_MT86HT Manual General Information - Manual (Page 3)

Doc. No. 003162 Rev. F 1 - 3 Models MT86, MT86HT
CHAPTER 1 - GENERAL INFORMATION FLUID COMPONENTS INTL
Options
• Enclosures
Explosion-proof NEMA 7 electrical enclosure is
available for both the flow element and flow
transmitter that complies with NEC Code, Class I,
Divisions 1 & 2, Groups C & D; Class II, Divisions
1 & 2, Groups E, F, & G.
• Flow Display Indicators
1) A three-and-one-half digit Flow Rate Display.
2) An eight digit Flow Totalizer Display.
• Available Outputs (up to four
module circuit boards)
Switch point: DPDT relay at 2 or 10 amp,
115 Vac.
Milliamp driver:
Current loop, 4-20 or 10-50 mA.
Analog voltage output:
0-5, 0-10, or 1-5 Vdc.
Remote sensor diagnostic alarm:
SPDT relay, 6A at 115 Vac.
• Rate Limit Board
Permits adjustment of the rate of change of the
output signal with respect to the rate of change of
the input signal. This option is used when the
measured flow is fluctuating and a stable output
signal is needed.
• Mass-to-Volume Converter
Changes the mass flow signal to a signal
representing actual cubic feet per minute or feet per
second (actual velocity).
• Accessories
The FC81 Field Calibrator simplifies calibration
verification of an MT86/MT86HT in the field.
This device provides the variable resistance
required to input a Delta "R" test value and a
digital read-out of the test output signal.