20ma user, 20ma factory, 20ma user 4-20ma factory – Fluid Components International ST100 Series Configuration Software User Manual
Page 13
ST100 Series Configuration Software
Fluid Components International LLC
9
The Configuration branch offers 6 Tab selections
Tab Name
Tab Description
Password Level
Output
Sets: 4-20mA channels zero and span values, Freq and Pulse parameters
User
4-20mA User
Manual mA Output loop check, Configur/Enable NAMUR fault
User
4-20mA Factory
Sets 4-20 mA Output DAC
Factory
Options
View System Setup Parameters
Factory
HART
Configuration Information
Factory
Modbus
Communication Parameters
User
[User password 2772]
To verify the current configuration of any setup parameter, select the Get From Device button on any of the Setup menus. After changing any of the
setup parameters, select the Send To Device button. Verify the parameter change has been accepted by the instrument by selecting the
Get From Device once button again. The new parameters that were change should now be displayed. The Configuration Tab screens are shown
below.
4-20mA User
4-20mA Factory