Grace Digital GDI-AQSHR200 Schooner II - Manual (Page 4)

P.3
SET UP
TRANSMITTER
1. Connect the AC power adaptor included with your unit to electrical wall outlet.
2. Plug the AC power adaptor included with your unit in the jack located on the
rear of the transmitter. Option 4 X “AA” size ALKALINE batteries can be used
to power the transmitter for portability. NOTE: ensure battery polarity (+/-) are
matched and correctly aligned correct when inserting the batteries in the
compartment
3. Turn on the transmitter by setting the POWER switch to the ON position, and
the POWER LED (blue) on transmitter will start flashing.
4. The retractable audio cord located at the front of transmitter can be connected
to an audio output jack of any audio source (i-Pod, i-Phone, MP3, Hi-Fi,
MP3/CD/VCD/DVD players, etc.)
5. When the transmitter receives an audio signal, the blue SIGNAL LED and the
red POWER LED will illuminate together. If the blue SIGNAL LED does not
illuminate, ensure the audio source is turned on and properly connected to the
jack.