Grace Digital GDI-AQSHR200 Schooner II - Manual (Page 7)

P.6
NOTE: IF disruption should occur (signal breaks up), press the “SCAN”
auto-tuning button on the speaker to maximize best reception.
If you hear interference from other components, switch between the channels on
the transmitter and press the
“SCAN” auto-tuning button for best reception.
NOTE: batteries should be removed from the transmitter & speaker in cases of
extended storage periods. Move the speakers indoors when weather conditions
are extreme.
6. Outdoor, Water Use & Weather Conditions
 Schooners II speaker is designed to be used in conservative outdoor
conditions
 The speaker should not be operated in extreme temperature
 The transmitter and adapters must NOT be used in any type of water body
or in a moist or wet environment.
WARNING: The power adaptor included with your unit is intended for indoor
environments and use. Do NOT use the power adapter in moist or wet
environments. Where there is a chance of rain, you may operate the speaker with
battery power.
TROUBLE SHOOTING
NO SOUND
- Check that the batteries are fully charges on the speaker
- Check there is not too much water retention inside the speaker grill. Turn
over the speaker and let the water drain out from the speaker grill.
- Ensure the AC/DC adaptor is fully inserted into the AC outlet and the power
connection input on the transmitter.
- Ensure the speaker is switch ON.
-
Speaker’s battery capacity is low, connect the AC/DC adaptor to the speaker.
- Ensure the TV or audio component is ON.
- The volume of speaker is too low, adjust the volume to an appropriate level.
DISTORTED SOUND
- Press the “AUTO-TUNE” button on the speakers to find the transmitter frequency
- Check there is not Too much water retention inside the speaker grill. Turn
over the speaker and let the water drain out from the speaker grill.
- Change the position of the channel selector on the transmitter. Press “AUTO
TUNE” button on the speaker.
- Ensure the volume level of speaker is adjusted properly.
- The speaker is too far away from the transmitter, move it closer.
- Audio input level of the audio signal is too low. Turn up the audio source volume
- The Transmitters audio input level is too high, lower the audio source volume level
- Ideally the audio source is ON and volume level is set to at 50-75% of maximum.