Chapter 2 system setup, 1 removing the cover – Advantech SPC-530 User Manual
Page 8
SPC-530 User's Manual
5
2.1 Removing the cover
Chapter 2 System Setup
The SPC-530 series is an ATX-compatible computer designed for industrial applications. This rugged
chassis meets the EIA RS-310C 19" rackmount standard.
Setting up your SPC-530 series requires only a screwdriver and a small amount of time. Before you
begin, you should also gather together all of the cards you plan to install, as well as the disk drives you
plan to use.
WARNING:
Disconnect all power from the chassis before you install
the CPU cards. Unplug the power cord from the wall,
Do not just turn off the power switch. If you are not sure
what to do, take the job to an experienced professional.
2.1 Removing the cover
There are screws near the top, along the sides, and on the rear to secure the cover to the chassis.
Remove them, and then you can lift the cover free of the chassis. See Figure 2.1 below: