Hydrotech PURA Max and Max Plus Point-of-Use Cooler 1240 Reverse Osmosis Unit Installation Manual - Manual (Page 4)

4
Quick Connect Pentek Cartridge Installation Instructions Cont’d
3.
Attach the end of the ¼” feed line that was installed in step 2 into the open fitting on the bottom right side
of the leak detector. Attach the end of the ¼” line from the leak detector, labeled “To Filter”, into the inlet
of the filter. Connect the sediment and carbon filter with a ¼” tubing.
4. Attach the cold water tank ¼” supply tubing, labeled “From Filtration”, (furnished with the unit) to the outlet
of the filter.
5. Mount both the sediment and carbon cartridge to the bracket located inside the cooler.
6. A ¼” shut off valve can be attached to the feed water line.
7. Follow the steps 9 to 19 given in the page 8 of the PURA Max or Max Plus manual (54754).
Sediment Cartridge
Carbon Cartridge
¼” Tubing