CAME Gard12 - Manual (Page 6)

- pag. - pag. - pag. - pag. - pag.
6 6 6 6 6
- english - - english - - english - - english - - english -
3 - INSTALLING THE BARRIER
DESCRIPTION OF ASSEMBLY PROCEDURE
a) remove the cover of the housing (by lifting) and remove the sides
of the housing (by raising and withdrawing them from below); clean
the cement bases and free the bolts on the anchor stays by
removing the protection tape and nuts;
b) position and mount the
housing on the mounting
base;
c) position and mount the
fixed support for the barrier
bar, and make sure it is in
perfect longitudinal alignment
with the housing;
g) check for misalignment and adjust if necessary; then, firmly tighten
the bar onto the fork and firmly tighten the fork onto the housing.
d) with the aid of a stand and the fixed
support, place the barrier bar at the
approximate height and axis of
operation;
e) install the fork and unite the two
mounting jaws on the barrier bar, but
do not tighten the bolts;
f) next, mount the barrier bar on the
terminal plates of the rotation shaft,
but do not tighten the bolts;
e
f
f
e