American Audio UCD-100 - Manual (Page 20)

© American Audio ® - www.americanaudio.com - UCD-100 Instruction Manual Page 20
14. PITCH BEND
this function will momentarily increase or decrease a tracks playback speed using the (-) & (+) PitCh but-
tONS (11). the maximum pitch bend percentage allowed is +/-16%. the pitch bend function will work in con-
junction with the PitCh SLiDEr 118) pitch setting. for example, if the PitCh SLiDEr (11) is set to a 2% pitch
gain the pitch bending process will begin at 0% and wi
ll continue to the maximum of - /+16%.
PITCH BEND BUTTONS (11)
the (+) PitCh bEND buttON (11) will provide a speed bump and the (-) PitCh bEND buttON (11) will pro-
vide a slow down. the extent to which the speed changes is proportionate to the amount of time the button
is pressed. for example, if the (+) PitCh bEND buttON (11) is held down continuously, the disc speed will
increases and will continue to increase until it reaches a maximum of 16% speed gain. When you release the
(+) PitCh bEND buttON (11) the disc speed will automati
c
ally return to it’s previous speed.
Holding down or tapping on the (+) PitCh
bEND buttON (11) will provide a speed
bump in the playback pitch.
Holding down or tapping on the (-) PitCh bEND
buttON (11) will provide a slow down in the
playback pitch.
figure 18
figure 19
JOG WHEEL (18)
the JOG WhEEL (18) will temporarily bend
the pitch if a track is in play mode. turning
the wheel in a clockwise direction will increase
your track pitch and turning the wheel in a
counter-clockwise direction will slow your
track pitch. the speed you rotate the JOG
WhEEL (18) will determine pitch bend percent-
age, to a maximum of +/-100%.
figure 20
BaSiC OPEraTiON