2 linking two main stations with fiber, Linking two main stations with fiber – Clear-Com HLI-FBS User Manual
Page 39
4.1.2 Linking two Main Stations with Fiber
1. Insert an HLI-FBS Fiber interface module in each station. Use any of the three slots available.
Note:
Ensure that the Main Station is powered down before inserting modules.
2. Plug an SFP Transceiver into one HLI-FBS port on each station.
3. Connect Two Fibers from one HLI-FBS port on one station to one HLI-FBS port on the other
station. If using Single connector fiber,make sure that Tx on one goes to Rx on the other.
4. Power up both stations. Verify that the green LED on each HLI- FBS port is flashing.
5. Go to Networking->Stations menu on each station. You should see two entries on each screen
indicating that each station properly sees itself and the other station.
6. Go to Networking->Linking->Link Station menu on each station and select Enabled. You now
have an 8 channels system and can start assigning channels to Main Stations and Beltpacks.
Note:
You should see a Link icon
on the Main Station display.
Figure 11: Linking two stations with Fiber
37
HelixNet Partyline User Guide