Panel connectivity, Panel connectivity -5 – Clear-Com AES-6 User Manual
Page 11
Vitec Group Communications
AES-6 Digital Interface Instruction Manual
1 - 5
Table 1-2: AES-6 Hardware Fault Codes
PANEL CONNECTIVITY
The amber port status LEDs on the front panel display the connection
status of each port on the rear card. If a panel connection is detected
on a port the status LED for that port lights continuously.
In mono mode each LED shows the status of the port as described in
Table 1-3. In stereo mode the LEDs operate in pairs reflecting the
pairing of the ports. The first LED in each pair (LED 1,3 and 5)
provides the connection status for the primary channel as described for
mono mode (Table 1-3) while the second LED in the pair will flash at
1Hz with a mark:space ratio of 25:75 indicating that the port is in stereo
mode. This will occur as a result of the DIP switch setting rather than a
connection and the LED will flash even if nothing is connected to the
primary port.
CPU LED CODE
LED 1
LED 2
LED 3
LED 4
LED 5
LED 6
MEANING
Flash
1
Flash
Off
Off
Off
Off
Off
RAM test fail
Flash
2
Off
Flash
Off
Off
Off
Off
Corrupt Code Image
Flash
3
Flash
Flash
Off
Off
Off
Off
FPGA Flash Erase
Fail
Flash
4
Off
Off
Flash
Off
Off
Off
FPGA Load Fail
Flash
5
Flash
Off
Flash
Off
Off
Off
FPGA Test Fail
Flash
6
Off
Flash
Flash
Off
Off
Off
UART Check Fail
Flash
7
Flash
Flash
Flash
Off
Off
Off
UART Local Loop
Fail
Flash
8
Off
Off
Off
Flash
Off
Off
Not Used
Flash
:
Flash
Flash
Off
Flash
Off
Off
Not Used
Flash
63
Flash
Flash
Flash
Flash
Flash
Flash
FPGA Image
missing, waiting for
download