AudioEngine Speaker - Manual (Page 4)

Connecting your system
Step 1– Connecting the Speaker Wire
Connect the
RED (+) and BLACK (-) terminals from the left speaker to the
corresponding terminals on the right speaker using the included speaker
wire. Be sure to match the gold-colored side of the speaker wire with the
RED (+) terminals and the silver-colored side to the BLACK (-) terminals on
each speaker.
As the Audioengine 5 speaker system is self-powered, do not connect the
speaker terminals to the speaker outputs of a stereo receiver.
Detailed Procedure:
1 Use your thumb and finger to unscrew the binding post connectors.
2 Insert each speaker wire into the holes on the side of binding post
connectors.
3 Retighten the binding posts with your fingers.
4 The stripped portion of the wire should be secured firmly in each
connector.
Repeat the procedure to connect the other end of the speaker wire to the
other speaker. Make sure that none of the speaker wire strands have come
in contact with an adjoining terminal.
Box Contents
Included with the speakers:
t Power supply

t
Speaker cable (16AWG), 2 meters (~6.5 feet)

t 1⁄8” mini-jack audio cable, 2 meters (~6.5 feet)
t 1⁄8” mini-jack audio cable, 20 cm (~8 inches)

t Drawstring power supply bag
t Drawstring cable bag
t DrawString speaker bag (2)

t Setup Guide
audioengine 2 setup guide audioengine 2 setup guide 4 5
Assembled in China
100-240V~ 50/60Hz 1.8A
17.5V 2.0A ± INPUT: OUTPUT: + –