Equipment setup, Battery charger setup, Connect ac power supply – Clear-Com BS200 User Manual

Page 11: Charge batteries, Section 2

Advertising
background image

SECTION 2. EQUIPMENT SETUP

BATTERY CHARGER SETUP

IMPORTANT! – Before installing the system, connect the AC power supply to the AC40A Battery Charger
and plug it into an electrical outlet. Charge all the batteries for the Beltpacs and/or WH200 Headsets while the
other equipment is being installed. Charging time is about 2.5 hours.

Connect AC Power Supply

Attach the AC power supply cable connector to the screw connector on the battery charger.
Plug the power cord connector into the AC power supply.
Plug the power cord into an electrical outlet.

The red lights on the charger will come on and go off, and then the yellow lights will come on and stay on.

6

Charge Batteries

Up to four batteries can be charged in the battery
charger at the same time. The battery status lights
next to each charging port are explained below.
Up to six fully charged batteries can be stored in the
battery storage ports.
Insert a battery in each of four charging ports

until it clicks in place.

A yellow light next to each charging port stays on

while the port is empty. When a battery is in a
charging port, a flashing yellow light next to it
indicates CHARGE PENDING, which means the
battery is too hot. Adjust the room temperature or
move the charger to a cooler area. When a battery is
in a charging port, a yellow light on steady next to it
means CHARGE FAILED. If this happens, follow
the instructions on the side of battery charger.

A red CHARGING light next to a battery port

stays on while a battery in the port is charging.
A green READY light next to a battery port goes
on when a battery in the port is fully charged.

Store fully charged batteries in storage ports.

Batteries should not be left in charge ports after being
fully charged. If a battery is left in a charge port for
more than three weeks, the yellow indicator may light
up. In this case, it does not indicate a faulty battery.

Charged batteries

in storage ports

Battery in

charging port

Empty

charging ports

Power cord

connector

To electrical

outlet

Power supply

cable connector

AC40A Battery Charger

AC power supply Power cord

Advertising
This manual is related to the following products: