Clear-Com BS200 - Manual (Page 19)

If the registration is successfully completed:
• A voice message in the Headset will say “Power on, Headset #, Version #, Begin registration, Registration
complete, …”
• After a delay of up to 15 seconds, the STATUS display will show the ID number assigned to this Headset for
about 10 seconds.
NOTE: ID numbers are assigned sequentially as 0 thru 9, A, b, C, d and E.
• The power light on the Headset will remain on steady green.
• Repeat Steps 1 to 3 above for each Headset to be registered.
If registration failed:
• A voice message in the Headset will say “Power on, Headset #, Version #, Begin registration, …” The
power light on the Headset will be blinking red, and there may be a delay of up to 90 seconds before you
hear “Registration failed” and the STATUS display (#3) goes blank.
• Press RESET (#16) on the base station. To press RESET, insert a small paper clip or similar object into
the RESET hole at the lower-left corner of the base station front panel. When the STATUS display (#3)
becomes blank, press the REGISTER button (#17) and register the Headset again. If registration fails
again, call your dealer for assistance.
16 17
2 3
If you try to register more than 15 WH200 Headsets and/or Beltpacs and/or Speaker
Stations to a base station
:
• An F (for registration “Full”) will appear on the STATUS display (#3) on the base station and you will
hear “Registration failed” in the Headset.
• Clear all current registrations by pressing the CLEAR/BAND button (#2) and RESET (#16) at the same
time. To press RESET, insert a small paper clip or similar object into the RESET hole at the lower-left
corner of the base station front panel. Continue holding the CLEAR/BAND button after you release
RESET, until the clear code “c” (lower case) appears on the STATUS display.
• Register all active WH200 Headsets, one at a time.
Previously registered Beltpacs and Speaker Stations must also be re-registered.
14