Adaptec 5ANA-940 - Manual (Page 101)

8-11
Installing ATM Software for Novell NetWare
The system scans for available drivers.
8 In the Specify a directory path screen, type the following path
and press Enter:
A:\
9 Insert the ALANE Driver for Novell NetWare v1.0 diskette in a
diskette drive, verify the directory path, and press Enter.
10 From the Select a driver to install menu, select ALANE.LAN
and press Enter.
11 At the Do you want to copy driver ALANE.LAN? , select Yes and
press Enter.
The system copies the Adaptec ATM software from the
diskette to the hard disk drive.
12 From the Board ALANE_1 (Driver ALANE) Actions menu,
select Select/Modify driver parameters and protocols and
press Enter.
13 Press F3 to manually set IPX frame types.
14 From the Frame Type List, select the appropriate frame type(s)
and press F10.
15 From the ALANE_1 Protocols menu, select any other protocols
needed, such as
TCP/IP or AppleTalk , and press Enter.
16 In the ALANE_1 Parameters section, configure the LANE
Client by changing the following parameters, as needed.
Parameter
Default
Value Possible
Values
Description
MAXIMUM
TRANSFER
RATE 1516 1516,
4544,
9234,
18190 Specifies the maximum
transfer size the ELANE
should support.
ELANE ID 0 0, 1, 2, 3 Identifies the slot
occupied by the
ELANE. The
ANA-5910/5930/5940
supports up to 4
emulated LANs,
numbered 0–3.