Hach-Lange RTC103 N-Module User Manual
Hach-Lange Equipment
Advertising
Table of contents
Document Outline
- RTC103 N-Module
- Real-Time Control System for Ammonium Removal
- Section 1 Technical data
- Section 2 General Information
- Section 3 Installation
- Section 4 Parameterization and operation
- 4.1 Operating the sc controller
- 4.2 System setup
- 4.3 Menu structure
- 4.4 1-Channel RTC103 N-Module parameterization on sc1000 controller
- 4.5 2-channel RTC103 N-Module parameterization on the sc1000 controller
- 4.6 Select sensors
- 4.7 Control programs
- 4.8 Automatic program change
- 4.9 Explanations of nitrification controller parameters
- 4.9.1 SRT MODE
- 4.9.2 SRT (MANUALLY)
- 4.9.3 DAILY SURPLUS MASS
- 4.9.4 COD-TKN RATIO
- 4.9.5 MIN NITRIFERS CONC.
- 4.9.6 MAX NITRIFERS CONC.
- 4.9.7 MODEL CORRECTION FACT.
- 4.9.8 SUBSTIT. DO FOR MODEL
- 4.9.9 NH4-N SETPOINT
- 4.9.10 P FAKT NH4 (only if NH4-N measurement in effluent is available for feed back control)
- 4.9.11 INTEGRAL TIME NH4 (only if NH4-N measurement in effluent is available for feed back control)
- 4.9.12 DERIVATIVE TIME NH4 (only if NH4-N measurement in effluent is available for feed back control)
- 4.9.13 Min DO
- 4.9.14 Max DO
- 4.9.15 SMOOTHING
- 4.10 Explanations of DO CONTROL (For DO control option only)
- 4.11 INPUTS
- 4.12 OUTPUTS
- 4.13 Volume
- 4.14 MODBUS
- 4.15 Displayed measurement values and variables
- Section 5 Maintenance
- Section 6 Troubleshooting
- Section 7 Replacement parts and accessories
- Section 8 Contact information
- Section 9 Warranty and liability
- Appendix A MODBUS address setting