INSTEON Mini Remote Switch 2342-242/2444A3WH, 2342-442, 2342-542 Manual - Manual (Page 11)

Page 11 of 16 2342-242/2444A3, 2342-442, 2342-542 Rev: 1/21/2014 7:24 AM
Beeper Behavior
Command Method
Beeper Disabled
(Default)
Beeper Enabled
On Tap - Single Beep
Off Tap - Single Beep
Fast-On Double-Tap - Single Beep
Fast-Off Double-Tap - Single Beep
Begin Bright Press & hold - Single Beep
Begin Dim Press & hold - Single Beep
Setup Action Beeper
Enter Setup Mode, Transition to next setup mode or Exit
Setup Mode
Single Beep
Setup successful, return to Ready Mode Double-Beep
Return to Ready Mode after a longer than 3 minute time-
out
Long Beep (3 seconds)
Failure to add a scene responder Long Beep (3 seconds)
Exiting Stuck Button Long Beep (3 seconds)
LED Behavior during Setup
Mini Remote has a two-color LED (Green & Red) which displays helpful information.
LED State Meaning
Blinking Green slowly Add Responder Setup Mode, or
LED on/off Setup Mode
Blinking Red slowly Remove Responder Setup Mode
Double-Blinking Green slowly Multi-Add Responder Setup Mode, or
Beeper on/off Setup Mode
Double-Blinking Red slowly Multi-Remove Responder Setup Mode, or
Keypad Configuration Setup Mode
Factory Reset
The factory reset procedure clears all settings from Mini Remote including INSTEON scenes.
1) If possible, unlink (remove) all scene responders prior to performing factory reset
2) Turn Mini Remote off (slide power switch to left)
3) Press & Hold Set Button
4) While continuing to hold the Set Button, turn Mini Remote back on (slide power switch to the right)
Mini Remote will beep and its LED stays solid green
Mini Remote will emit a long beep