INSTEON SmartLinc (2412N) Manual - Manual (Page 12)

12
®
Rev. 6/19/2012 11:45 AM
Adding and Controlling an IP Camera from SmartLinc
1. Log onto http://smartlinc.smarthome.com and click the Room Settings icon (cube with a wrench).
2. Next to the room in which the camera is located, click Add URL to Room.
3. Type in the camera’s access URL. Example: http://192.168.0.200:80/ImageViewer?Mode. Note
that there is usually a URL extension that allows you to only view the camera image, such as
/ImageViewer?Mode in the example.
4. Click Save and Test. The SmartLinc interface will find and synchronize the camera feed and the
camera image will load on the room’s control page.
If you have a Smarthome Wireless IP Security Camera (75790) or a Panasonic Plug & Play Camera
(971363), you can view live camera feeds through the SmartLinc interface.
Adding a Timer to a SmartLinc Scene
1. Log onto http://smartlinc.smarthome.com and
select the room and then the scene for which
you want to set the timer.
2. To set the time at which you want the scene to
activate, scroll down to the On Time field.
• Manually enter the time (hh:mm format) and
select “AM” or “PM.”
• Or select “Sunrise” or “Sunset,” which will
automatically sync based on your location (see
Setting Up SmartLinc).
3. To set the time at which you want the scene to
deactivate, scroll down to the Off Time field.
• Manually enter the time (hh:mm format) and
select “AM” or “PM.”
You can set an automatic on/off timer for each scene you program in SmartLinc.