INSTEON SmartLinc (2412N) Manual - Manual (Page 7)

7
®
Rev. 6/19/2012 11:45 AM
3. Set up SmartLinc IP address and port number.
• Click the Settings (wrench) icon.
• Click Change Network Settings.
• Update the IP address to the one you forwarded in
step 1.
• Change “Edit DHCP” to Disabled.
• Click Save.
• Cycle power on SmartLinc: unplug it, wait 10
seconds and plug back in. While unplugged, write
down SmartLinc’s INSTEON I.D. for for step 5.
4. Test settings.
• Enter SmartLinc’s IP address and port number into
your browser. Example: http://192.168.0.20:8080
• If homepage doesn’t load, check your formatting and
that you entered the correct IP address and port.
5. Register SmartLinc for remote access.
• Log onto http://smartlinc.smarthome.com.
• Click New User Registration.
• Enter your username and password (twice).
• Enter SmartLinc’s INSTEON I.D., including dots.
• Click Submit.
Log Into SmartLinc Away From Home
1. Log onto http://smartlinc.smarthome.com.
2. Click “I’m not at home.”
3. Type in your username and password.
4. Click Log In.
Access HTML SmartLinc Interface
The default web interface requires JavaScript. However, to access the interface from a web-enabled mobile
device, use the HTML version.
1. Log onto http://smartlinc.smarthome.com.
2. Enter “hindex.htm” on the end of the redirected web address.
3. Hit Enter to load the HTML interface.