INSTEON SwitchLinc Relay (Dual-Band) (2477S) Manual - Manual (Page 9)

Page 9 of 18 2477S - Rev: 1/21/2014 7:27 AM
2) Tap SwitchLinc on (or off if desired for the link).
Load will be on (or off).
3) Press and hold SwitchLinc Set button until it double-beeps.
Controller LED will stop blinking.
Unit will double-beep.
11
4) Test by tapping controller button on and off.
SwitchLinc will respond appropriately.
Note: The link just created is one-way. See Make SwitchLinc an INSTEON Controller to add another link
to create a two-way link and keep the two products in synch.
Make SwitchLinc a Controller
Configure using home automation software (such as HouseLinc) or follow the steps below to control an
INSTEON device from SwitchLinc.
1) Press and hold SwitchLinc set button until it beeps.
SwitchLinc LED will start blinking green .
2) Adjust the responder(s) to the state you want when scene
is activated from SwitchLinc (e.g., 50%, 25% or even off).
3) Press and hold responder Set button until it double-beeps
(or until its LED flashes).
SwitchLinc LED will stop blinking.
Responder LED will stop blinking and unit will double-
beep
4) Test by tapping SwitchLinc paddle on and off.
Responder will toggle between the scene on-level and off
5) If you wish to add another responder, repeat steps 1-5 (or see Add Multiple Responders).
Notes:
- The link just created is one-way. See Make SwitchLinc an INSTEON Responder to add another link
to create a two-way link and keep the two products in synch.
- If you wish the SwitchLinc load to be off when the link is activated (such as for an “all-off” scene),
turn off the load in step 2.
Groups (Synchronizing Devices)
Devices in a group share all the same settings (e.g., on-level, ramp rate). This keeps all group members
synchronized. Every device in a group is both a controller of and responder to all the other devices. The
most common example of a group is a 3-way lighting circuit with 2 switches, such as switches at either
end of a hallway.
Configure using home automation software (such as HouseLinc) or follow the steps below to set up a 3-
way circuit with two switches. For simplicity, we will assume that the desired group level is on.
Example: Set up a 3-way circuit with two switches, A and B
1) Turn A and B on.
2) Press and hold A set button until it beeps (or LED blinks).
A’s LED will start blinking green .
3) Press and hold B set button until it double-beeps (or LED flashes).
B will double-beep.
A will double-beep and its LED will stop blinking.
4) Press and hold B set button until it beeps (or LED blinks).
11 Most models
SwitchLinc
(Controller)
Responder