INTELLINET NETWORK 515566 Net Toner and Probe Kit - Manual (Page 3)

3
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS ™
Net Toner and Probe Kit, Model 515566.
With testing leads and modular cables for individual wire tests or modular
jack tests, this handy device helps you attain the quick, reliable results
you need in order to get — and keep — your wired systems up and running.
Additional features:
• Tests datacom, telecom, security, video and audio networks
• Two-position switch for single or multi-tone signal
• LEDs for line polarity, continuity and voltage
• Enhanced talk battery mode provides power for voice communications
over inactive pairs
• Replaceable plastic tip to prevent accidental shorts
• Trace or identify wire or cables in a bundle or group
• Alligator clips, RJ45 jack, RJ12 plug, optional F-connector
• Lifetime Warranty
Electric Shock Risks & Precautions
• Avoid using this device in wet, damp or excessively humid environments.
• Before using the test lead or accessory, check that it is clean and dry,
and that the insulation is in good condition.
• Do not open the battery compartment when test leads are connected
to a live circuit, or when the unit is switched on.
• Never connect the Toner or Net Probe to a live wire from a non-
compatible telephone/network system. Doing so may damage the
tracer and/or the equipment.
Live Circuit Warnings
Acceptable voltage – The tester is designed to bear voltage conditions
commonly found on live telephone wires: It can safely be connected to
wires carrying 48 V DC or less at less than 80 mA, or 24 V AC.
Unacceptable voltage – Do not connect the tester to wires bearing over
48 V DC or at 80 mA or 24 V AC, or higher. Do not connect to live AC
circuits: Doing so causes an extreme shock hazard and damages the
tester. When connecting the tester to a previously untested circuit, the
tester should always be in OFF/VOLT mode (the middle switch on the
top switched to the middle position).
3